Setting

Lamp control

Lamp control

This function allows you to change brightness of the screen.

High

Brighter than the Normal mode.

Normal

Normal brightness

Eco

Lower brightness reduces the lamp

 

power consumption and extends the

 

lamp life.

Lamp life control

Select the lamp operation when the total lighting time of a lamp exceeds the recommended total hours of use.

Mode 1

The lamp can be turned on even after

 

exceeding the recommended total

Mode 2

hours of use.

The lamp can be turned on even after

 

exceeding the recommended total

 

hours of use. But the projector turns off

Note:

automatically after 3 minutes.

 

Lamp mode cannot be changed for a while after turning on the projector. Lamp needs some time to stabilize after the power is turned on. Stored lamp mode will be active after the lamp is stabilized.

If Mode 2 has been selected and the projection lamp exceedes the recommended total hours of use, the replacement icon will be displayed at the time of power- on. Then the projector will turn off after 3 minutes.

Lamp replacement icon

The Lamp replacement icon will not appear when the Display function is set to Off (p.45), during Freeze (p.25), or No show (p.26).

Remote control

This projector provides two different remote control codes: the factory-set initial code (Code 1) and the secondary code (Code 2). This switching function prevents remote control interference when operating several projectors or video equipment at the same time.

When operating the projector in Code 2, both the projector and the remote control must be switched to Code 2.

To change the code for the projector:

Select either Code 1 or Code 2 in this Setting Menu.

To change the code for the remote control:

Press and hold both the MENU and IMAGE buttons together for 5 seconds or more. After changing the code, make sure the remote control operates properly.

Note:

Lamp life control

Remote control

When different codes are set on the projector and on the remote control, any operation cannot be made. In that case, switch the code on the remote control to fit the code on the projector.

If the batteries are removed from the remote control for a long period of time, the remote control code will be reset.

52

Page 52
Image 52
Sanyo PLC-XW200K, PLC-XW250K owner manual Lamp control, Lamp life control Remote control