Sanyo PLC-XW57 owner manual Fan control, Lamp counter, Factory default

Setting

Fan

This function provides the following alternatives in the cooling fans' operation after turning off the projector. (p.19)

L1 . . . . . . normal operation

L . . . . . . slower and lower-sound than the normal operation (L1), but it takes longer to cool the projector down.

Note:

Setting "Fan control " to On 1 or On  affects L operation in "Fan".

Fan control

This projector provides Fan control function in the Setting menu.

Choose the running speed of cooling fans from the following options according to the ground elevation under which you use the projector.

Off . . . . . Normal speed. Set this function to "Off" when using the projector in non-high altitude environment.

On 1 . . . . Faster than Off mode. Select this mode when using the projector in high altitudes (about 1,00 meters or more above the sea level) where the fans have less cooling effect.

On  . . . . Faster than On 1 mode. Select this mode when using the projector in higher altitudes than above where the fans have lesser cooling effect.

Note:

Fan noise becomes louder in On 1 and On .

Lamp counter

This function is used to reset the lamp replacement counter. When replacing the projection lamp, reset the lamp replacement counter by using this function. See page 55 for operation.

Factory default

This function returns all setting values except for the user logo, PIN code lock, Logo PIN code lock, and the lamp counter to the factory default settings.

Quit

Exit the Setting Menu.

Factory default

Select Factory default and this box appears. Select [Yes], and the next box appears.

Select [Yes] to activate it.

50