APPENDIX
LAMP REPLACE COUNTER
Be sure to reset the Lamp Replace Counter after the Lamp Assembly is replaced. When the Lamp Replace Counter is reset, the LAMP REPLACE Indicator stops lighting.
1 | Turn projector on, press MENU button and | Lamp counter |
| ||
| MENU will appear. Press POINT LEFT/RIGHT buttons to |
|
| move a red frame pointer to SETTING Menu icon (refer to |
|
| page 43). |
|
2 | Press POINT UP/DOWN buttons to move a red frame pointer |
|
| to “Lamp counter” and then press SELECT button. The next |
|
| box appears. |
|
3 | Press POINT UP/DOWN buttons to select “Reset” and then |
|
| press SELECT button. The message "Lamp replacement |
|
| counter reset?" is displayed. Move the pointer to [Yes] and |
|
| then press SELECT button. |
|
4 | Another confirmation dialog box appears and select [Yes] to |
|
| reset Lamp Replace Counter. |
|
Select Lamp counter and this box appears. Select [Reset] , and the next box appears.
Select [Yes] and the next box appears.
Select [Yes] to activate it.
NOTE : Do not reset the Lamp Replace Counter until after the Projection Lamp is replaced.
LAMP HANDLING PRECAUTIONS
This projector uses a
●Lamp lifetime may differ from lamp to lamp and according to the environment of use. There is no guarantee of the same lifetime for each lamp. Some lamps may fail or terminate their lifetime in a shorter period of time than other similar lamps.
●If the projector indicates that the lamp should be replaced, i.e., if the LAMP REPLACE INDICATOR lights up, replace the lamp with a new one IMMEDIATELY after the projector has cooled down.
( Follow carefully the instructions in the LAMP REPLACEMENT section of this manual. ) Continuous use of the lamp with the LAMP REPLACE INDICATOR lighted may increase the risk of lamp explosion.
●A Lamp may explode as a result of vibration, shock or degradation as a result of hours of use as its lifetime draws to an end. Risk of explosion may differ according to the environment or conditions in which the projector and lamp are being used.
IF A LAMP EXPLODES, THE FOLLOWING SAFETY PRECAUTIONS SHOULD BE TAKEN.
If a lamp explodes, disconnect the projector’s AC plug from the AC outlet immediately. Contact an authorized service station for a checkup of the unit and replacement of the lamp. Additionally, check carefully to ensure that there are no broken shards or pieces of glass around the projector or coming out from the cooling air circulation holes. Any broken shards found should be cleaned up carefully. No one should check the inside of the projector except those who are authorized trained technicians and who are familiar with projector service. Inappropriate attempts to service the unit by anyone, especially those who are not appropriately trained to do so, may result in an accident or injury caused by pieces of broken glass.
47
