Sanyo SCP-2700 Connections Basic TV Connections, Optional, Preferred TV Connections

Connections (Continued)

Basic TV Connections

Make one of the following connections, depending on the capabilities of your existing equipment.

RF coaxial connection

Connect the RF.OUT jack on the DVD+VCR to the antenna in jack on the TV using the 75-ohm Coaxial Cable supplied (R).

Note

If you use this connection, tune the TV to the DVD+VCR’s RF output channel (CH 3 or 4).

How to set the DVD+VCR’s RF output channel

1.When the DVD+VCR is turned off, press and hold CHANNEL (v/V) on the front panel for about five seconds.

It will turn itself on and “RF03” or “RF04” appears in the dis- play window.

2.Press CHANNEL (v/V) on the front panel or CH/TRK (v/V) on the remote control to change the RF output channel (CH 03 or CH 04).

3.Turn off the DVD+VCR.

Audio/Video connection

1	Connect the DVD/VCR VIDEO OUT jack on the
	DVD+VCR to the video in jack on the TV using the

video cable supplied (V).

2 Connect the Left and Right DVD/VCR AUDIO OUT jacks on the DVD+VCR to the audio left/right in jacks on the TV (A1) using the supplied audio cables.

Note

If you use this connection, set the TV’s source selector to VIDEO.

Rear of TV

ANTENNA	AUDIO INPUT		VIDEO
INPUT			INPUT
	L	R

R A1 V

Rear of DVD+VCR

Optional, Preferred TV Connections

Note

You can ONLY watch and listen to DVD playback through the connections shown below.

S-Video connection

1 Connect the S-VIDEO OUT jack on the DVD+VCR to the S-Video in jack on the TV using the optional S-Video cable (S).

2 Connect the Left and Right AUDIO OUT jacks of the DVD+VCR to the audio left/right in jacks on the TV using the supplied audio cables (A2).

Component Video (Color Stream®) / Progressive Scan (ColorStream® pro) connection

If your television is a high-definition or “digital ready” television, you may take advantage of the DVD+VCR’s progressive scan output for the highest video resolution possible.

If your TV does not accept the Progressive Scan for- mat, the picture will appear scrambled if you try Progressive Scan on the DVD+VCR.

1 Connect the COMPONENT / PROGRESSIVE SCAN VIDEO OUT jacks on the DVD+VCR to the corresponding in jacks on the TV using an optional Y Pb Pr cable (C).

2 Connect the Left and Right AUDIO OUT jacks of the DVD+VCR to the audio left/right in jacks on the TV (A2) using the supplied audio cables.

Notes

–Set the Progressive Scan to “On” on the setup menu for progressive scan signal, see page 18.

–When you use Component Video signal, set the Progressive Scan to “Off” on the setup menu.

–Progressive scan does not work with the analog video connections (yellow VIDEO OUT jack).

Rear of TV

S-VIDEO	COMPONENT / PROGRESSIVE SCAN			AUDIO INPUT
INPUT		VIDEO INPUT
	Pr	Pb	Y	R	L

S C A2

Rear of DVD+VCR

12