DVAS Instruction Manual Additional Information
11 Additional Information
11.1 Required Components
•(1) Slide Kit and Mounting Hardware
•(1) Pair Accuride Slide Rails
11.2 Rail Kit Installation
Step 1. Remove inner slide rail as shown in FIGURE 46. Press down on latch to release.
Figure 46 Remove Slide Rail
EN 36
NOTE: Make sure the flange is on the bottom edge. Step 4. Attach left and right front (short) extended
brackets to the outer rail using 2 x 8300045 M4 screws, 2 x 8300045 washers , and
2 x 8300044 nuts for each bracket (FIGURE 49).
NOTE: Make sure the flange is on the bottom edge.
Step 2. Attach inner slide rail to chassis using 3 x 8300047 M4 screws, as shown in FIGURE 47.
NOTE: When attaching the extended brackets, first attach them loosely. Adjust the length to fit the cabinet, and then tighten.
Figure 49 Attach (Short) Extended Brackets
Step 5. Attach outer rail to chassis using 4 x M6 x 12 screws and cage nuts per rail, 2 at each end.
Step 6. Slide chassis into outer rail, carefully making sure the chassis is level with the slide as in FIGURE 50 (it’s easier if the drives and power supplies are removed).
Figure 47 Attach Rail to Chassis
Step 3. Attach left and right rear (long) extended brackets to the outer rail using 2 x 8300045 M4 screws, 2 x 8300045 washers, and
2 x 8300044 nuts for each bracket (FIGURE 48).
Figure 50 Attach Outer Rail and Slide Chassis in
Figure 48 Attach (Long) Extended Brackets
Bosch Security Systems 20 January 2004