DVAS Instruction Manual Before You Begin
The main frame will change to the Network Settings page. Insert the new settings into the text boxes.
Figure 8 Network Settings
How to Set IP Address
Decide whether to use DHCP (Dynamic Host Configuration Protocol), or a manually set IP address. Use the radio buttons to select the desired value. If choosing DHCP, no further values are required. It is recommended that you have your DHCP server reserve a static IP for your DVAS Series disk array.
IP Address
If setting up the network manually, enter a free IP address into the text box.
Subnet Mask
Type the appropriate subnet mask for the class of your network. In most cases 255.255.255.0 is fine, but Bosch recommends contacting your IT administrator for further assistance.
Gateway
Type the IP address of your Internet gateway here.
Primary/Secondary DNS
Type the IP address of both the Primary and Secondary DNS into the text boxes.
EN 16
Web Page Auto Refresh
Determines whether the web pages should be reloaded at a specified interval, to show any changes to the system
When all settings have been updated, press Save Configuration.
Restart the system to activate these changes.
6.4Quick Configuration
THIS PROCESS CLEARS ALL DATA!
The DVAS can be fully configured with the Quick Config function. To access this function, click Quick Config, in the
When the Quick Config page loads, select one of two configurations by clicking on one of the page tabs at the top of the page. Configuration options are:
1 DVR CONFIG: Select if your unit is to be used with a single DVR.
2 DVR CONFIG: Select if you wish to attach two DVRs to the unit.
The selected DVR Config tab displays the status of the configuration, identifying the settings to be configured.
Figure 9 DVR Config
The status column (on the right side) will display either OK, or Needs Configuring. If all settings report OK, there is no need to continue. To continue with the automatic configuration, scroll to the bottom of the Quick Config window.
Bosch Security Systems 20 January 2004