DVAS Instruction Manual Before You Begin | EN 17 |
|
|
Check the check box and click Quickstart configure for
(x)DVR.
Figure 10 Quick Config Confirmation
Quick Config adjusts the settings required to configure the disk array to work with 1 or 2 DVRs. If prompted for a system reboot, manually cycle the power switches. Once the system reboots, Quick Config has finished.
6.5Setting Up SCSI Interfaces
The DVAS Series disk array’s SCSI settings are preconfigured to work with Bosch DVRs, without any adjustments.
To accommodate future products, the SCSI settings may be altered. This section explains each setting.
To change the SCSI setting select System on the DVAS Series disk array’s main page.
SCSI ID
Use the drop down menu to choose the desired ID.
Termination
AUTOMATIC is the default setting and will work with all Bosch DVRs.
SCSI Max Transfer Rate
Defines the maximum speed of the SCSI bus. The default setting for the DVAS is Ultra2. This setting should only be changed if the DVR specifies a different setting.
Click Save Settings to save these settings.
Power cycle the unit so the new Network and SCSI settings are applied.
Figure 11 SCSI Interfacing
Select the SCSI tab to access the SCSI settings.
When the Configure SCSI page is loaded in the main frame, use the drop down menus to select the new setting for the SCSI host channels.
Figure 12 SCSI Settings
Bosch Security Systems 20 January 2004
