Sanyo SID-70 Brightness Shutter AGC, Sens-Up, Main Setup Lensdc 2.EXPOSURE White BAL ATW Ssdroff

Operating Your Camera

EXPOSURE SETUP
1.BRIGHTNESS	25
2.SHUTTER	---
3.AGC	HIGH
4.SENS-UP	OFF
5.RETURN

SHUTTER : You can select the shutter.

- A.FLK	: Select this when you experience picture flicker, this happens when there
	is a clash with the installed lighting frequency.
- ESC	: Select this to control the shutter speed automatically. If ESC is selected,
	the shutter speed is automatically controlled depending on the ambient
	illumination of the subject.
- MANUAL : You can control shutter speed manually.
	(NTSC MODEL : 1/60~1/120,000, PAL MODEL : 1/50~1/120,000)
- ---	: Shutter speed is fixed at 1/60sec(1/50sec).

Notes

•Set the shutter mode to --- if color rolling occurs.

•When the SHUTTER is set to ESC after selecting the Internal Synchronization Type, the picture may become unstable if the camera faces a bright fluorescent light. Therefore, take care when choosing the installation position.

•When the SHUTTER is set to MANUAL or A.FLK mode, SENS-UP will be disabled.

AGC(AUTO GAIN CONTROL) : The higher the gain level, the brighter the screen - but

the greater the noise.

- OFF : Deactivates the AGC function.

-LOW : Allows automatic gain control from 5.3dB to 32dB.

-HIGH : Allows automatic gain control from 5.3dB to 37dB.

SENS-UP : When it is night or dark, the camera automatically detects the light level and maintains a clear picture if this mode is activated.

- OFF : Deactivates the SENS-UP function.

- AUTO : Activates the SENS-UP function.

Notes

•If you set the Function Setup switch to ‘AUTO’ mode, You can adjust the brightness by increasing or decreasing the shutter speed. (x2 ~ x512)

•Note that the higher the zoom level, the brighter the screen, but the more likely it is that an after-image will appear.

•Although Noise, Spots, and Whitish symptoms may occur in SENS-UP operation when the zoom level is increased, this is normal.

RETURN : Select this to save the changes in the EXPOSURE menu and return to the SETUP menu.

White Bal (White Balance)

Use the White Balance function to adjust the screen color.

1.When the SETUP menu screen is displayed, select ‘White Bal’ by using the Function Setup switch so that the arrow indicates ‘White Bal’ .

2.Select a desired mode using the Function Setup switch.

MAIN SETUP

1.LENSDC 2.EXPOSURE

3.WHITE BAL ATW

4.SSDROFF

※Select one of the following 5 modes, as appropriate for your purpose.

ATW	: Select this when the color temperature is between 1,700˚K and
	11,000˚K.
OUTDOOR	: Select this when the color temperature is between 1,700˚K and
	11,000˚K. (sodium light inclusion)
INDOOR	: Select this when the color temperature is between 4,500˚K and
	8,500˚K.
MANUAL	: Select this to fine-tune White Balance manually. Set White Balance
	first by using the ATW or AWC mode. After that switch to MANUAL
	mode, fine-tune the White Balance and the Function Setup switch.

COLOR DOME CAMERA 18 User Guide COLOR DOME CAMERA 19 User Guide