Installation
1)Separate the dome cover by turning
2)Separate the shield case by pulling from the camera body.
Installation
When using the Ceiling bracket
* To install the dome cover on the camera
|
|
| Latch | body, turn the latches in locking direction |
|
|
| as shown in the figure 1. | |
|
|
|
|
Locking direction
| Main Body |
[Figure1] | (Camera) |
| Shield Case |
Ceiling bracket
An arrow for installing directions
M4 tapping screw (provided)
CAMERA |
1)Hold the ceiling bracket (located where the arrow points to) and separate it from the main body of the camera by rotating it
2)Place the separated ceiling bracket so that the “Front” side faces the area to be monitored and install it with the M4 tapping screws.
3)To combine the main body with the ceiling bracket, make sure that the pan base fixation screw face the opposite side of the “Front” side of the ceiling bracket and rotate it clockwise.
4)Adjust the camera lens to face the area to be monitored and fix the main body and the dome cover by aligning the grooves and rotating the body clockwise.
Unlocking direction | Locking direction |
(Clockwise) | |
| Dome cover |
Locking direction
Unlocking | Pan Base | |
direction | ||
fixation | ||
| ||
| screw |
Dome cover
Notes
•The installation should be done by qualified service personnel or system installers.
•If the ceiling material is not strong enough to hold the installation screws, the camera may fall off. Reinforce the ceiling as needed.
•To change the position of the cable, take away the Hole Cover and pass the cable through.
Original position of the cable
Hole Cover
M4 tapping screw
Notes
•If you want to install the camera with the ceiling bracket combined, fix it using two M4 tapping screws at the side of the main body (refer to the
COLOR DOME CAMERA 10 User Guide | COLOR DOME CAMERA 11 User Guide |
