Sanyo SPW-XR254EH56 Installing the Ceiling Panel, When Removing the Ceiling Panel for Servicing

2-7. Installing the Ceiling Panel

(1)Lift the ceiling panel and position it to align the panel hook with the panel catch of the indoor unit.

(5)Install the air filter and air-intake grille by perform- ing the steps in section 2-6 in reverse.

NOTE

The ceiling panel must be mounted in the correct direction. Note that the 2 catches of the panel differ in size.

Confirm that the catches are correctly matched be- tween the ceiling panel and the indoor unit body.

(2)Next, check to see that the ceiling panel is prop- erly aligned with the seamline of the ceiling. If it is not, remove the ceiling panel and slightly readjust the indoor unit body to the proper suspension point.

(3)When the ceiling panel has been properly aligned, use the supplied 4 mounting screws (M5) with washers to permanently fasten the ceiling panel.

(4)Install the wiring connector from the ceiling panel to the connector in the electrical component box of the indoor unit. After installing the connector, use the clamp on the body of the indoor unit to secure the wiring.

NOTE

Rehook the safety string before closing the air-intake grille.

2-8. When Removing the Ceiling Panel for Servicing

When removing the ceiling panel for servicing, remove the air-intake grille and air filter, disconnect the wiring connector inside the electrical component box, and then remove the 4 mounting screws.

Unit body

Ceiling panel

Panel catch

Panel catch

Electrical(arrange facing downwards) component box

Electrical component box

Clamp

Ceiling panel wiring connector

(2 locations)

Screws M5 with washer (supplied)

Air filter

Air-intake grille

1973_X_I

Fig. 2-15

10