Installation

1Using the supplied pattern sheet, drill the holes for the cables and screws. ¥ Pull out the cables from the ceiling.

2Attach the supplied mounting plate to the ceiling using commercially-available screws. (Screw: M4/No. 8 or equivalent) Length: 40 mm/1.6 in or more, Head: φ 8.3 mm/0.3 in

¥ Loosen the screw (A) and remove the cable holder (B).

(B)

(A)

3Hook the safety cable attached on the camera base to the mounting plate.

4Connect the cables from the ceiling to the camera cables. ( Page 5 “Basic Connections”)

①After connecting each of the terminals (LAN, USB, HDMI), put the cable holder (B) back to its original position so as to hold all the cables in place, and tighten the screw (A).

②Using the supplied fixer (C), tidy the wiring by binding all the cables to make the installation easier.

(B)

(A)

(C)

After binding, cut off the excess portion of the fixer.

When routing cables through the side face of the camera

Remove the wire gutter cover (AA).

(AA)

(C)

If you use a USB cable or an HDMI cable,

 

 

secure it along with the LAN cable using the

 

 

supplied fixer (C) so that the cables don’t

 

 

easily come off.

 

 

When you route the cables after installing

 

 

the camera, be sure to carefully handle the

 

 

cables so as not to strongly pull them.

 

 

9