Sanyo VCC-HD5400, VCC-HD5400P ⑬Side Cover, A B C D, BSD Card slot, ■External HDD, DSD CARD button, ■SD memory card, CPower indicator, Enable recording:, Disable recording:

Name and Function of Each Component

This indicator lights up when the camera is powered on.

When the camera is on, this indicator blinks to indicate the following camera statuses:

¥Deactivation of recording to SD memory card in progress

¥Firmware update in progress

¥An SD memory card error occurred (Fast blink)

¥Disable recording: The power indicator blinks when this button is pressed, and stays lit when the SD memory card is prepared to be removed.

¥Enable recording: The power indicator blinks when this button is pressed, and stays lit when the SD memory card is recognized.

¥Before you insert an SD card, be sure to turn off the camera.

¥If you insert an SD card, format it via network operation on the SD/HDD screen. ( Electronic manual)

To record live video on a SD memory card, open the cover as shown below and insert the card into the card slot until you hear a click.

Press the SD CARD button and, after confirming that the indicator lamp has stopped blinking and now stays lit, take out the SD card.

Power indicator

SD CARD button

Use the optional hard disk case (VA-HDC4000) to install the SANYO-specified 2.5" SATA hard disk drive and connect the drive to the EX-HDD terminal.

For detailed information on the hard disk case including hard disk installation, refer to the instruction manual supplied with the hard disk case.