Parts Names and Functions
■Rear
| ② | ⑤ | ⑤ Lens terminals | |
① | ⑥ VIDEO OUT connector (BNC type) | |||
| ||||
|
| Used to output image signals. | ||
|
|
| Connect to video equipment such as a | |
|
|
| monitor. |
④
ALARM OUT
POWER VIDEO OUT ALARM IN
DC12V
⑥ | ⑦ Control terminals | |
When connecting the cable, press and hold | ||
| ⑦ | down the protrusion of the terminal, insert the |
| cable into the terminal, and then release the | |
| ||
| protrusion. | |
③
COM
LAN
• COM terminal (Earth terminal) |
GND
LINK
| ⑧ | • ALARM IN terminal |
| ||
|
| Connect to a device such as an external |
CLASS 2 WIRING
alarm switch or an infrared sensor.
⑨
①Flange back fixing screw
②Flange back adjustment lever
③AC24V / DC12V terminals
Connect this terminal to the power supply.
•When the camera is turned on, the POWER lamp lights.
④Power lamp
•ALARM OUT terminal
Used to connect to an external buzzer or lamp.
When an alarm is detected, the device connected to the terminal notifies that an alarm is detected.
⑧LAN connector
Used to connect the camera to your network.
⑨LINK lamp
When connected correctly to the network, the lamp will illuminate 3 seconds after the power is turned on.
Flashes while data is being transferred.
■ Side |
| ① Camera setting switches (P7) |
② | ③ | ② White balance manual adjustment |
controls | ||
|
| R: Red adjustment |
① |
| B: Blue adjustment |
| ④ ③ Iris adjustment control (LEVEL) | |
|
| This can only be adjusted when using a DC- |
|
| type automatic iris lens. |
|
| ④ Reset button (RESET) |
|
| If pressed for approximately 5 seconds, it |
|
| initializes the various NETWORK SETTINGS |
|
| settings (such as IP address) for network |
|
| operations. |
5
