4Peel off the release-coated paper of the supplied cover sheet and cover the back of the camera completely with the sheet, aligning the hole with the central shaft.

5.Mount the camera unit to the base plate

1Aligning the ribs (K) and hook (L) on the camera unit with the slot on the base plate, push the camera unit until it clicks.

K

L

2Tighten the camera unit securely using the supplied screw (M).

M

6.Adjust/Check the video image from the camera

bSet up the camera remotely (see page 7).

bCheck the settings screen or camera angle on a portable monitor (see page 7).

7.Install the dome cover

See “Installing on the Ceiling” (see page 2).

When Moving the Camera from

Wall to Ceiling

1Remove the cover sheet, being careful not to distort it.

2Push the spring and release the camera.

3Mount the camera by following the opposite procedure from that indicated in “4. Change the camera position” (see page 3).

• Check that the flat cable is not caught between the chassis.

•When removing the cover sheet, be careful not to deform the sheet. Deformation of the sheet (such as large wrinkle or bend on the sheet) may cause the sheet to contact inside the dome cover when it is re-attached, which may prevent normal operation of the camera.

4