Installing on the Wall
1.Remove the base plate from the camera unit
See “Installing on the Ceiling” (see page 1).
2. Install the base plate
1Pass the connection cables through the cable hole on the base plate.
2Set the base plate on the wall with the arrow (↑) pointing upward. Then, secure the base plate using the screws and washers (B) (4 places).
•Length: 35 mm or more
•Diameter: 3.5 to 5.0 mm
•Height of screw head: 5 mm or less (washer included)
2
B
B
Make sure to tighten the screws properly. Using screws of sizes other than specified may cause the unit to fall.
3. Remove the dome cover
While pressing down the cabinet section (D) on the opposite side of the rib mark (C), open the dome cover in the arrowed direction.
C 
Push
D
4. Change the camera position
1Push the spring (E) and set free the hooks from the base chassis. Lift and turn the camera in the arrowed directions so that the back of the camera becomes visible.
E
2Rotate the camera so that the position of the locks (F) is upside down.
F
3Align the locks (G) with the slots (H) on the base chassis, push the spring (J), and mount the camera.
Keep the flat cable away from the chassis.
G
J
H
3