Adjusting the Camera

bSetting up the camera remotely

Use of the separately ordered Camera Control Unit (VAC-70) is recommended for setting and adjustment of this camera. The Camera Control Unit allows you to adjust the camera angle (pan/tilt, zoom) as well as perform advanced settings from the main menu. For details, see the instruction manual for the Camera Control Unit.

VAC-70

Video in

VIDEO OUT CAMERA

DC IN 3V

Ð +

BNC type

RG-6U coaxial cable 300 m max.

Do not forget to disconnect the Camera Control Unit once you have finished setting/adjustment.

Checking the settings screen or camera angle on a portable monitor

(These checks are unnecessary when using the separately ordered Camera Control Unit (VAC-70).)

Connect the MONITOR OUT pin and the GND pin on the circuit board to a monitor using an alligator clip cable. Do not forget to remove the cable after you have finished checking.

A dedicated MONITOR OUT connector is provided for portable monitors.

bTo check the settings screen and make changes

1) Hold down the SET button (1) for over a second. The main menu appears.

2)Select a menu by pressing the Select button (2) up and down, then press the SET button.

3)Select the setting item and value by pressing the Select button left and right.

GND

MONITOR

bTo check the camera angle and make changes

1)Press the Select button up, down, left, and right during live mode (with no menu displayed).

You can set the camera angle (pan: d or c, tilt: j or l).

2)Press the SET button, then press the Select button left and right.

You can set the zoom (wide: d, tele: c).

•The active operation switches over between pan/tilt and zoom each time you press the SET button.

SET

UP

LEFT

RIGHT

DOWN

1

2

7