Sharpness, Color, Saturation, Metering, EN-34

Sharpness

This sets the sharpness of the image that will be captured. * Hard / Standard / Soft

This sets the color of the image that will be captured.

* Standard / Vivid / Sepia / B&W / Blue / Red / Green / Yellow / Purple

This sets the saturation of the image that will be captured. * High / Standard / Low

This sets the metering method for calculating the exposure.

* Center:	Averages the light metered from the entire frame, but gives greater
	weight to the subject matter at the center.
* Spot:	A very small portion of the center of the screen is measured to
	calculate the correct exposure.
* Average:	The exposure is measured all of the image area.

This sets the recording method at the time of capturing images.

* Single:	Captures one image at a time.
* Continuous:	Permits continuous capture of up to 3 images.
* AEB:	Permits 3 consecutive images in the order of standard exposure,
	underexposure and overexposure compensation.
* Album Shot:	Creates an album-like layout to combine 3 shots into a single image.
* Burst:	Permits continuous photography while pressing and holding the
	shutter button. As long as you hold the shutter button pressed,
	images are captured until the memory capacity is exhausted.
* Cont. flash:	Permits continuous capture of up to 3 images with flash.
* Pre-shot:	Select a background by 1st shot, the image shown on display will be
	transparent, then take the 2nd shot on the basis of 1st image. Image
	of 1st shot is only a guiding tool, it won't be saved on SD card.
	Normally this function is used when taking a portrait picture and the
	background is selected by the model instead of the photographer.
* Coupl.shot:	Uses separate areas to combine two shots. You can include yourself
	in the shot.

If this function is set to “On”, the camera takes a quick shot without focusing. * On / Off