SATO XL4xxe manual Electric Checks and Adjustments, previous home next

This explains how to check DC power supply, I-Mark sensor level, Gap/center hole sensor level, ribbon sensor level, side hole sensor level, R-corner hole sensor level and jump hole sensor level. Ensure printer power is OFF. Then remove the VR cover on the back of the printer and perform the following steps.

Additional equipment required

TP Test Module

Digital Multimeter

STEPS

1Attach the connector from the TP Test Module to the test port on the MAIN PCB. Note correct positioning of connector. Nibs on the connector are placed down on the PCB in the forward position.

2Attach the ground probe of the Digital Multimeter to the TP Test Module ground pin (GND PIN).

3Attach positive probe of the Multimeter to the +SIG PIN on the TP Test Module terminal.

4Turn printer power on and rotate the dial to a dial POS on the TP Test Module. Record the values from the Multimeter.

5Confirm voltages are correct. If not, then replace parts or adjustment sensor level. Refer to Check and Adjustment chart.

6After performing test, put the VR cover back to the printer.

Cable to TP Test Module

Cable to PCB

Ground	PIN SIG PIN		Dial
		TP Test Module

EZ Manual: XL4xxe 2

Electric Checks and Adjustments

previous home next

Barcode SATO International Pte Ltd