Scag Power Equipment GC-STT manual Assembly Instructions for 72 Cutter Decks, Weight

18.Install the hose from the blower assembly to the hopper hood. Secure using the 8-1/2" clamps.

-NOTE-

When installing this catcher on machines equipped with an air cooled engine the discharge hose should be shortened to 56" in length.

19.	Install the bag assemblies.
20.	Install the weight support bar to the front of the
	machine by resting it directly on top of the caster
	support arms and sliding it tight against the frame
	of the machine. Secure the weight bar to the
	machine using (2) bar clamps, (4) 3/8-16 x 1-1/2"
	bolts and (4) 3/8-16 elastic stop nuts. See Figure

5.1ASSEMBLY INSTRUCTIONS FOR 72" CUTTER DECKS

-NOTE-

Use the illustrated parts list as a part

number reference when following the

assembly instructions.

1.Remove all packaging materials. Lay out the mounting hardware and the catcher assembly parts for easy access. Prepare the work area making sure that it is a clean, safe environment.

2.Remove the discharge chute from the cutter deck. See Figure 5-1.

4-6.

21. Install the weight assemblies to the weight

support bar and secure them to the bar using the

1/2"x 6-1/4" pin and lanyard. See Figure 4-6.

WEIGHT (5x)

REMOVE DISCHARGE CHUTE AND HARDWARE

REMOVE (2)

U-NUTS

INSTALL PULLEY

ON RH SPINDLE SHAFT -

ON TOP OF EXISTING

SPINDLE DRIVE

PULLEY	REMOVE EXISTING
	RT. SIDE BELT
	COVER

RIGHT SIDE OF

CUTTER DECK SHOWN

LANYARD

ELASTIC STOP PIN

NUT

BAR CLAMP

	BOLT
WEIGHT SUPPORT BAR	2002 GC-STT Install Art 3-5

FIGURE 4-6

22. Operate and test.

(Note: Some parts not shown for viewing purposes.)

FIGURE 5-1

-NOTE-

Do not discard the discharge chute or mounting hardware. The discharge chute MUST be reinstalled anytime the grass catcher has been removed from the machine.

WARNING

DO NOT OPERATE WITHOUT DISCHARGE CHUTE, MULCHING KIT, OR ENTIRE GRASS CATCHER INSTALLED

9