Scag Power Equipment STC48V-26BS, STC52V-23BV, STC61V-23BV Lidok EP #2 found at industrial shops

Section 7

MAINTENANCE CHART - RECOMMENDED SERVICE INTERVALS (CONT'D)

		HOURS					Procedure	Comments
Break-In	8		40	100	200	500
(First 10)
					X		Apply grease to fittings	See paragraph 7.2
					X		Check hardware for tightness
					X		Change engine oil filter	See paragraph 7.4
					X		Check hydraulic oil level	See paragraph 7.3
						X	Replace engine fuel filter	See paragraph 7.5
						X	Drain hydraulic system and	See paragraph 7.3
							replace hydraulic oil	Use SAE 20W50
								Motor Oil
						X	Replace hydraulic oil filter	See paragraph 7.3
						X	Adjust electric PTO clutch	See Scag Dealer

7.2LUBRICATION - GREASE FITTING LUBRICATION CHART (SEE FIGURE 7-1)

		LUBRICATION		NO. OF
	LOCATION	INTERVAL	LUBRICANT	PLACES
1	Caster Wheel Pivot *	500 Hours/Yearly	Chassis Grease	2
2	Caster Wheel Bearings	100 Hours/Bi-Weekly	Chassis Grease	2
3	Brake Actuator	200 Hours/Monthly	Chassis Grease	2
4	Cutter Deck Bellcranks	100 Hours/Bi-Weekly	Chassis Grease	4
5	Cutter Deck Pusharms	100 Hours/Bi-Weekly	Chassis Grease	2
6	Control Pivot	100 Hours/Bi-Weekly	Chassis Grease	2
7	Cutter Deck Spindle	40 Hours/Weekly	+Lithium MP White Grease 2125	3
8	Brake Handle	200 Hours/Monthly	Chassis Grease	1

*PROCEDURE: Remove grease cap, part number 481559. Remove plug, part number 482028-01, and install grease zerk. Apply grease to the fitting until new grease appears at the top of the caster extension. Remove the grease zerk and reinstall the plug. Reinstall the grease cap. Special tool, part number 47007, is recommended for use in the installation of the grease cap.

+ Compatible Greases:	Mobilix #2 found at Mobil Service Stations
	Timken Lithium Multi-Use #2 found at industrial shops
	Shell Alvania #2 found at Shell Service Stations
	Lidok EP #2 found at industrial shops

29