Scag Power Equipment STT61V-25KBD-SS manual Operating Instructions

R

Section 4

OPERATING INSTRUCTIONS

Caution

Do not attempt to operate this mower unless you have read this manual. Learn the location and purpose of all controls and instruments before you operate this mower.

4.1Controls And Instrument Identification

Before operating the mower, familiarize yourself with all mower and engine controls. Knowing the location, function and operation of these controls is important for safe and efficient operation of the mower.

1.Ignition Switch (Figure 4-1). The ignition switch is used to start the engine and has four positions; PREHEAT, OFF, ON, and START.

2.Mower Deck Switch (Figure 4-1). Used to engage and disengage the mower drive system. Pulling up on the switch will engage the deck drive. Pushing down on the switch will disengage the deck drive.

3.Glow Plug Indicator (Figure 4-1). Yellow indicator turns on when the key switch is turned to the PREHEAT position. Glow plugs must be preheated for 5 to 10 seconds before starting the engine.

4.Engine Throttle Control (Figure 4-1). Used to control the engine speed. Pushing the lever forward increases engine speed. Pulling the lever back decreases engine speed. Full back position is the IDLE position. Full forward is the cutting position.

5.Voltmeter (Figure 4-1).Indicates the condition of the charging system. When the engine is running, in normal operating conditions, the needle should be in the 12 to 14 volt range.

6.Oil Pressure (Figure 4-1). Indicates engine oil pressure. Reference the engine operator's manual for further information.

LEFT STEERING

CONTROL

PARKING BRAKE

DECK LIFT

RIGHT STEERING

CONTROL

CUTTING HEIGHT

ADJUSTMENT

WATER TEMPERATURE

MOWER DECK SWITCH

OIL PRESSURE

CONTROL

DECK RELEASE

GLOW PLUG INDICATOR

ENGINE

THROTTLE

CONTROL

IGNITION SWITCH

FUSES

vOLTMETER

DUMP vALvE

C

SEAT BELT

FUEL GAUGE

HOURMETER

STT-25KBD2007CONTROLS

Figure 4-1. Controls and Instruments

12