Section 4 | R |
7.Hour meter (Figure
8.Fuse Holders (Figure
9.Left Steering Control (Figure
10.Right Steering Control (Figure
11.Parking Brake Control (Figure
12.Fuel Tank Gauge (Figure
13.Dump Valve Control Levers (Figure
DUMP VALVE
CONTROL
2007 STTDVC
Figure 4-2. Dump Valve Control
14.Deck Lift Foot Lever (Figure
15.Cutting Height Adjustment (Figure
16.Deck Release Lever (Figure
17.Temperature Gauge (Figure
18.Seat Belt (Figure
4.2 Safety Interlock System
The mower is equipped with a safety interlock system that prevents the engine from starting unless the deck drive is disengaged, the parking brake is engaged, the steering control levers are in the neutral position and the operator is in the seat. The interlock system shuts off the engine if the operator leaves the seat with the steering control levers not in the neutral position and/or the cutter blades engaged and the parking brake not engaged.
WARNING
Never operate the mower with the interlock system disconnected or malfunctioning. Do not disengage or bypass any switch; injury to yourself and others or property damage could result.
4.3 Initial Run-In Procedures
First Day of Use or Approximately 10 Hours
1.Check all belts for proper alignment and wear at 2, 4 and 8 hours.
2.Change the engine oil and oil filter after the first 20 hours of operation. (See Section 7.4.)
3.Check hydraulic oil level in reservoir. (See Section 7.3.)
4.Check for loose hardware. Tighten as needed.
5.Check interlock system for proper operation. (See Section 4.2.)
6.Check tire pressure. Adjust pressure if necessary. (See Section 7.10)
13