Scag Power Equipment STWC61V-27CV, STWC52V-25KA, STWC61V-26KA-LC manual Section, Lubrication

Section 7 R

MAINTENANCE CHART - RECOMMENDED SERVICE INTERVALS (CONT'D)

		HOURS
						Procedure	Comments
Break-In	8	40	100	200	500
(First 10)
				X		Apply grease to fittings	See paragraph 7.2
				X		Check hardware for tightness
				X		Change engine oil filter	See paragraph 7.4
				X		Check hydraulic oil level	See paragraph 7.3
					X	Replace engine fuel filter	See paragraph 7.5
					X	Drain hydraulic system and	Use SAE 20W50 Motor Oil.
						replace hydraulic oil	See paragraph 7.3
					X	Replace hydraulic oil filter	See paragraph 7.3
					X	Adjust electric PTO clutch	See Scag Dealer
					X	Change coolant	See paragraph 7.11

7.2 Lubrication

GREASE FITTING LUBRICATION CHART (SEE FIGURE 7-1)

	LOCATION		LUBRICATION INTERVAL		LUBRICANT	NO. OF
						PLACES
1	Caster Wheel Pivot *		500	Hours/Yearly	Chassis Grease	2
2	Caster Wheel Bearings		100	Hours/Monthly	Chassis Grease	2
3	Brake Actuator		200	Hours/Monthly	Chassis Grease	2
4	Cutter Deck Bellcranks		100	Hours/Bi-Weekly	Chassis Grease	4
5	Cutter Deck Pusharms		100	Hours/Bi-Weekly	Chassis Grease	2
6	Control Pivot		100	Hours/Bi-Weekly	Chassis Grease	2
6	Cutter Deck Spindle		40 Hours/Weekly		+Lithium MP White Grease 2125	3
7	Brake Handle		200	Hours/Monthly	Chassis Grease	1
+	Compatible Greases:	Mobilix #2 found at Mobil Service Stations
		Ronex MP found at Exxon Service Stations
		Super Lube MEP #2 & Super Stay-M #2 found at Conoco Stations
		Shell Alvania #2 found at Shell Service Stations

Lidok EP #2 found at industrial shops

Timken Lithium Multi-Use #2 found at industrial shops

*PROCEDURE: Remove grease cap, part number 481559. Remove plug, part number 482028-01, and install grease zerk. Apply grease to the fitting until new grease appears at the top of the caster extension. Remove the grease zerk and reinstall the plug. Reinstall the grease cap. Special tool, part number 47007, is recommended for use in the installation of the grease cap.

29