R
Section 7
- NOTE -
The front of the machine will have to be raised slightly to remove the blade bolt from the cutter spindle.
4.To install the new cutter blade, put the flat washer onto the blade bolt and slide the bolt into the hole in the cutter blade.
HEX
TO 75
SPINDLE
SHAFTCUTTER DECK
HEX HEAD
BOLT / NUT
SPINDLE
ASSEMBLY
| CUTTER BLADE |
| SPACER |
| CUTTER |
WASHER | BLADE |
| |
| HEX HEAD BOLT |
Figure 7-7. Blade Replacement
- NOTE -
Be sure that the blade is installed with the lift wing toward the top.
5.Install the spacer onto the blade bolt and insert the bolt into the cutter spindle shaft.
6.Install the hex nut to the blade bolt at the top of the cutter spindle. Secure the blades from rotating and torque to 75
7.10 Tires
Check the tire pressures after every 8 hours of operation or daily.
Caster Wheels | Flat Free |
Drive Wheels | 12 PSI |
7.11 Cooling System
(Liquid-Cooled Machines Only)
WARNING
To avoid burns, always allow the engine to cool before removing the radiator cap.
A. Checking Coolant Level
The coolant level should be checked before each day of operation.
1.Remove the radiator cap by turning it slowly counterclockwise to the first stop and allow any pressure to be released. Push down on the cap and turn counterclockwise to remove.
2.Visually check the coolant level. The coolant level should be up to the bottom of the filler neck as shown in Figure
- NOTE -
Refer to the coolant manufacturer's instructions for the proper coolant mixture ratio.
Fill to Bottom of
Filler Neck
Figure 7-8. Coolant Level
36