JVC GR-DVL9000 manual 16ENGETTINGSTARTEDCont, Remote Control Unit, Installing The Battery

16ENGETTINGSTARTED(Cont.)

Remote Control Unit

You can use the RM-V711U to control the camcorder. When using the remote control, be sure to point it at the remote sensor. The transmitted beam effective area for indoor use is approx. 5 m. The transmitted beam may not be effective or may cause incorrect operation if the remote sensor is directly exposed to sunlight or powerful lighting.

START/STOP Button (☞ pg. 69)

PAUSE IN connector (☞ pg. 63)

Zoom Buttons (☞ pg. 52)	AUDIO MONITOR Button
	(☞ pg. 68)
DISPLAY Button (☞ pg. 60)
T	W

SHIFT Button (☞ pg. 52, 62)

SLOW Rewind/Forward Buttons (☞ pg. 51)

Left/Right Buttons (☞ pg. 52)

FADE/WIPE Button (☞ pg. 64)

EFFECT Button (☞ pg. 53)

EFFECT ON/OFF Button (☞ pg. 53)

MBR SET Button (☞ pg. 62)

A. DUB Button (☞ pg. 68)

Down Button (☞ pg. 52)

INSERT Button (☞ pg. 69)

Up Button (☞ pg. 52)

Operation Buttons

(☞ pg. 52, 60, 68, 69)

R.A. EDIT Buttons (☞ pg. 65)

Installing The Battery

The RM-V711U uses one lithium battery (CR2025).

1 PULL OUT BATTERY HOLDER Pull out in the direction of the arrow while pressing the knob as shown.

2 INSERT BATTERY IN HOLDER Insert the battery in the holder, and be sure to have the “+” mark visible.

3 RE-INSERT HOLDER

Slide the holder back in until you hear a click.

Knob

•Read the caution concerning lithium batteries (☞ pg. 2).