Disconnecting the Battery for Transport

Image 15

Contents

User Manual Uninterruptible Power Supply3000/5000/6000 VA 200-240 Vac Tower/Rack Mount 3U Smart-UPS RTPage Introduction SpecificationsINSTALLATION Read the Safety Guide before installing the UPS Wiring and Connecting the UPS CONNECTING THE BATTERY MODULES AND ATTACHING THE FRONT BEZEL Use only interface kits supplied or approved by APC connectorWhen connecting grounding cable, disconnect the unit from the utility power outlet 2. Avoid using extension cords OPERATION On Battery Operation The UPS starts a self-test as part of this procedure. The self-testdoes not affect the voltage display FACTORY USER CONFIGURABLE ITEMSDEFAULT FUNCTION Adhere to National and local electrical codes when wiring the EPO Services 9 bits per second 9 data - bits 9 parity - none 9 stop bit9 flow control - none 5000/6000 VA models X YZ \ Replacing the Battery ModuleMAINTENANCE AND TRANSPORT Be careful during battery replacement, the battery modules are heavy Disconnecting the Battery for Transport The batterys may remain in the UPSREPLACING BATTERY MODULES CAUSE TROUBLESHOOTING, SERVICE, AND WARRANTY INFORMATIONPROBLEM AND POSSIBLE SOLUTION UPS OPERATES ON BATTERY ALTHOUGH NORMAL LINE VOLTAGE EXISTS FAULT AND OVERLOAD LEDS ILLUMINATE, UPS EMITS A SUSTAINED ALARM TONEFAULT LED ILLUMINATES REPLACE BATTERY LED ILLUMINATES Limited Warranty Service APC Worldwide Customer Support Radio Frequency WarningsREGULATORY

Schneider Electric 3000, 5000 Disconnecting the Battery for Transport, Replacing Battery Modules