Schumacher 94026879, 00-99-000659 Using the AIR Compressor, Estimated Time for Inflating

USING THE AIR COMPRESSOR

CAUTION: Read instructions of the product being inflated before using the air compressor. The air compressor is rated 250 PSI. Avoid over inflation. Do NOT exceed the manufacturer’s recommended pressures. Do NOT leave the air compres- sor unattended during use.

1.Remove air compressor hose wrapped in the back storage com- partment.

2.To inflate a tire, attach the permanent nozzle connected to the end of the air compressor hose and attach to tire stem. Flip down lever.

3.To inflate items other than tires, use one of the three nozzles stored in the center back left compartment. Slide the panel to the left to open. Attach nozzle to end of air compressor hose, attach to product and flip down lever.

4.The 3-way air compressor ON switch is located on the back lower left side. Note: There are two speeds of infla- tion: Slow – push switch left (I) or Fast, push switch right (II). Inflate product and be careful to monitor the air pressure on air compressor gauge located on upper right back side. DO NOT OVER INFLATE.

5.When product is inflated to proper air pressure, turn OFF air compressor by pushing air compressor switch to OFF (O).

6.Remove nozzle and hose from prod- uct. Store hose and nozzles in their compartments.

NOTE: Do not run for more than 10 min- utes maximum at a time. If you do, allow the PP-18400CI to cool down for 10 min- utes before using again. If the compressor overheats, the built-in thermal protection will turn the PP-18400CI off. Wait a few minutes and it will automatically restart.

ESTIMATED TIME FOR INFLATING

Vehicle Tires
13" to 16"	6 to 24 minutes
Bike Tire	1 to 3 minutes
Sports Balls	30 seconds

USING THE BUILT-IN SWIVEL LIGHT The built-in swivel light is located on the left side of the back of the PP-18400CI. With a fully charged internal battery, the built-in light should provide 18 to 26 hours of continuous useful light, depending on ambient conditions.

1.Position the PP-18400CI on a flat, stable surface near the intended work area.

2.Pull tab up to remove light from stor- age. Turn light in direction needed.

3.To turn light ON, push red button in back of light. The light and green LED will light.

4.To turn OFF, push red button. The light and green LED will turn off. Important: Turn off light before placing light in its storage space otherwise battery drain occurs.

5.Charge PP-18400CI as soon as pos- sible after using built-in light.

REPLACING THE BUILT-IN SWIVEL LIGHT BULB

1.Turn light off.

2.Pop out protective plastic lens cover.

3.Gently grasp the bulb and twist until notch in bulb lines up with retaining tab.

4.Insert a replacement bulb of same type and rating, and twist clockwise one quarter-turn to screw in new bulb.

5.Test light by switching light on and off.

6.Replace lens cover.