Back Panel Connectors

0003B4287797

 

 

AUDIO OUT

 

SABDQXTL

N0006246618

 

Pr

L

 

 

OPTICAL

IR

 

 

 

 

 

 

Pb

R

CABLE

 

 

 

OUT

 

 

 

 

 

 

AUDIO

 

 

 

 

 

OUT

 

Y

 

 

 

 

 

 

 

 

 

S-VIDEO

HDTV

DIGITAL VIDEO

 

1394 1394

DVI

OUT

AUDIO OUT

 

 

CAUTION

 

 

RISK OF ELECTRIC SHOCK

 

 

DO NOT OPEN

 

 

AVIS: RISQUE DE CHOC

 

 

ELECTRIQUE NE PAS OUVRIR

 

THIS DEVICE IS INTENDED TO BE ATTACHED

CABLE IN

 

TO A RECEIVER THAT IS NOT USED TO

 

 

RECEIVE OVER-THE-AIR BROADCAST

 

 

SIGNALS. CONNECTION OF THIS DEVICE

120 VAC

120 VAC

IN ANY OTHER FASHION MAY CAUSE

HARMFUL INTERFERENCE TO RADIO

60HZ 400W

60HZ 400W

COMMUNICATIONS AND IS IN VIOLATION

 

 

OF THE FCC RULES, PART 15.

BYPASS

 

1

2 3

4

5 6

7

8

9

10

1Connect to a 1394-equipped HDTV or consumer peripheral. Contact your cable service provider to determine if this port is supported in your area.

2Record your serial number and MAC address shown from this label on page 7 of this guide for future reference.

3Connect an optical cable to send a digital audio signal to a surround- sound receiver or other digital audio device.

4Connect to the DVI input port on your HDTV. Contact your cable service provider to determine if this port is supported in your area.

5Attach the IR Blaster cable to use with the optional VCR Commander™ Service. See Setting Up the VCR Commander Service on page 37.

6Connect an S-Video cable to send an S-Video signal to your TV or VCR. This signal is SDTV but higher- quality than other SDTV connections.

7Connect the HDTV (Y, Pb, and Pr) component output ports to the HDTV input on your HDTV. You must use these ports to provide HDTV signals to your HDTV.

1112 13 14 15

T10833

8Connect an RCA cable to send a digital audio signal to a surround- sound receiver or other digital audio device.

9Connect an RCA cable to Video Out and Left/Right Audio Out to send analog video and audio signals to a standard TV or VCR. This signal is SDTV.

10Connect a coaxial cable to Cable Out to send analog audio and video signals to a TV or VCR. These signals are SDTV video with mono audio.

11Connect RCA cables to Audio Out to send analog audio signals (left and right) to a stereo receiver or a TV with stereo inputs.

12Connect the coaxial cable that delivers the signal from your cable service provider.

13Connect an optional RF Bypass module to your set-top. This module allows you to view one channel while recording another. Contact your cable service provider to see if this service is available.

14Connect the power cord for another device to deliver power to that device.

15Connect the power cord provided to deliver power to the set-top.

12