Questions about Your Remote Control

The light flashes twice whenever you press a key.

The batteries are weak and should be replaced. Use two AA alkaline batteries.

The remote control keys do not function as expected.

Make sure that you press the appropriate mode key for the device you want to control.

Questions about Your VCR Commander Service

The VCR Commander Service does not turn on the power to the VCR for the scheduled recording or did not begin recording.

•Make sure that there is a blank tape in the VCR.

•Turn off the power to the VCR.

•Make sure that the IR Blaster is in front of or within 3 inches of the sensor window on the VCR.

•Make sure that the VCR timer is properly set. See Using the VCR Timer in the Scheduling a VCR Recording section of this guide.

•Try another VCR code for your VCR brand, or enter 0000. See the instruc- tions in Setting Up the VCR Com- mander Service on page 37.

The VCR Commander Menu option does not appear on the screen.

Your set-top is not authorized for VCR Commander Service, or your cable service provider does not offer VCR Commander Service. Call your cable service provider.

After entering your VCR code, the VCR will not turn on.

Try another VCR code for your brand, or enter 0000. See the instructions in Setting Up the VCR Commander Service on page 37.

You recorded an on-screen message (blocked barker), which states that the channel was not authorized.

The channel, time, or rating was blocked after the program was set. Verify that Parental Control is turned off before setting this recording.

47