CU1526, CU2026, CU3030
User Manual
Control Switches
There is a front on and off switch, located in the top center of the louvers. Switching this switch Off will immediately stop the machine. Switching it back on will cause the machine to restart in a timed harvest cycle. When that cycle is complete, normal ice making will resume.
Ice
The cuber drops ice in large sections. That ice will break up into random parts as it falls into the bin, but some large sections may remain on top of the ice in the bin. When removing ice, tap the groups of ice with an ice scoop to separate them into smaller units.
Using the ice will help to level it out and allow the machine to fill it to its maximum level.
The controller (located inside the cabinet) also has on and off switches, which can also switch the machine on and off, but their operation is different:
To switch the machine OFF, push and release the Off button. The machine will shut off at the end of the next cycle. To shut the machine off immediately, push and hold the Off button for 3 seconds.
To switch the machine ON, push and release the On button. The machine will go through a start up process and then resume ice making.
Heat
Air cooled models will generate heat when in operation. That heat is discharged out the front of the cabinet.
Noise
The ice machine will make noise when it is in ice making mode. The compressor, fan motor(s) if air cooled and water pump all produce some sound. It is also normal to hear some cracking just before the harvest cycle begins. In addition, during the harvest cycle the harvest assist solenoid will click twice as it pushes the ice out and returns to its normal position. The ice harvests as a unit or slab, which makes some noise when it impacts the bin. These noises are all normal for this machine.
May 2008
Page 13
