Scotts S2546 manual Using Booster Battery, Replacing Headlight Bulb

SERVICE ELECTRICAL

TO ENGINE

B

2.Connect positive (+) charger cable to positive (+) battery terminal.

3.Connect negative (–) charger cable to negative (–) battery terminal.

4.Plug in charger cord.

5.Charge battery using a 12 Volt battery charger at a rate of 6–10 amperes for a minimum of 1 hour and no more than

2hours.

6.Unplug charger cord. Remove charger cables.

7.Install battery. (See Removing and Installing Battery in this section.)

Using Booster Battery

cCAUTION: Avoid injury. Battery gas is explosive:

-DO NOT smoke while you charge battery.

-Keep all flames and sparks away.

-DO NOT charge frozen battery.

-DO NOT connect booster battery negative (-) cable to starting vehicle negative (-) terminal.

1.Connect positive (+) booster cable to booster battery positive (+) post (D).

GROUND

A

C D

VEHICLEBOOSTER

BATTERYBATTERY

2.Connect the other end of positive (+) booster cable to vehicle battery positive (+) post (A).

3.Connect negative (–) booster cable to booster battery negative (–) post (C).

4.Connect the other end of negative (–) booster cable (B) to engine ground away from battery.

Replacing Headlight Bulb

1. Lift hood.

A

M88559

2.Push in and turn bulb socket (A) 1/4 turn counterclockwise to remove.

3.Replace defective bulb with a new bulb.

4.Insert bulb socket into housing, push in and turn 1/4 turn clockwise to install.

5.Lower hood.

Service Electrical - Page 38