Cheetah 18 Installation Guide, Rev. A | 45 |
LC drives
Setting the SCSI ID jumpers
The SCSI ID for ST118202LC drives is normally set over the SCSI bus by the host system. You can also use the J6 jumper block to set the SCSI ID (see Figure 16).
Drive
Front
Jumper Plug (enlarged to show detail)
J6
SCSI ID = 0
SCSI ID = 1
SCSI ID = 2
SCSI ID = 3
SCSI ID = 4
SCSI ID = 5
SCSI ID = 6
SCSI ID = 7
SCSI ID = 8
SCSI ID = 9
SCSI ID = 10
SCSI ID = 11
SCSI ID = 12
SCSI ID = 13
SCSI ID = 14
SCSI ID = 15
Pin 1
(default)
Note:
[1]Do not remove cover from pins 13 through 20 (darkened area).
