ST11950 and ST12550 Installation Guide, Rev. D 41
2.Verify that all connections between the drive and the host system are correctly installed.
2.Prüfen Sie, ob alle Verbindungen zwischen dem Laufwerk und dem Host-System korrekt hergestellt sind.
3.Verify that you have correctly installed SCSI ID jump- ers (see Figures 3, 4, 6, and 7).
3.Stellen Sie sicher, daß die Kennungsbrü cken installiert sind. Siehe Abbildung 3, 4, 6, und 7.
4.Connect the 50-pin SCSI cable into the drive’s SCSI connector (shown earlier in Figures 3 and 4). Take care not to stretch or crimp this cable, and do not block the system’s cooling air flow with the cable.
The drive receives DC power through a 4-pin connec- tor mounted next to the SCSI connector. The output of a power supply must meet SELV (safety extra low voltage) as defined in IEC 950. Figure 16 provides the pin information for the DC power connector. To con- nect the DC power cable to the drive, insert the cable end into the drive’s DC power connector.
4.Schließen Sie das 50-polige SCSI-Kabel an den SCSI-Steckverbinder des Laufwerkes an (wie bereits in Abbildung 3 und Abbildung 4 gezeigt). Das Kabel
