Barracuda 4 Installation Guide, Rev. E | 31 |
2.Verify that all connections between the drive and the host system are correctly installed.
2.Prüfen Sie, ob alle Verbindungen zwischen dem Laufwerk und dem Host-System korrekt hergestellt sind.
3.Verify that you have correctly installed SCSI ID jump- ers (see Figure 10, 15 or 21).
3.Stellen Sie sicher, daß die SCSI-Kennungsbrncken. Siehe Abbildung 10, 15 und Abbildung 21.
4.Connect the 50-pin SCSI cable into the drive’s SCSI connector (shown earlier in Figures 1, 2 and 3). Take care not to stretch or crimp this cable, and do not block the system’s cooling air flow with the cable.
The drive receives DC power through a 4-pin con- nector mounted next to the SCSI connector. The output of a power supply must meet SELV (safety extra low voltage) as defined in IEC 950. Figure 9 provides the pin information for the DC power con- nector. To connect the DC power cable to the drive, simply insert the cable end into the drive’s DC power connector.
4.Schließen Sie das 50-polige SCSI-Kabel an den SCSI-Steckverbinder des Laufwerkes an (wie bereits in Abbildung 1, 2 und Abbildung 3 gezeigt). Das Kabel
