Seagate ST32155N/W/WC, ST31055N/W/WC, ST31051N/W/WC, ST32151N/W/WC manual

Hawk 2XL Family Installation Guide, Rev. C 13

_______________________________________________________________________________________________________________________

("X" means the function selection can be made with jumpers on that connector;

"Y" means the signal is available to host through that connec- tor).

Notes[ ] for Table 1:

[1]Use either J6 or J1-Aux, but not both.

[2]I/O connector J1 plugs directly into host. No jumper can be installed on J1. The host supplies the logic state of these function signals; causing the selection of these functions.

[3]The host can drive a remotely located Drive Activity LED using this signal.

[4]Use either J1 or J6, but not both.

[5]Jumper plugs can be used on J1-Auxiliary pins 1-2, 3-4, 5- 6 and 7-8 to set drive ID if desired, but usually a connector/ cable is plugged to J1-Auxiliary to run these signals to the host for remote ID selection.

[6]The host selects drive ID through J1.