6 | Cheetah 10K.6 FC Product Manual, Rev. B |
3.1Standard features
Cheetah 10K.6 FC drives have the following standard features:
•Integrated dual port
•Concurrent dual port transfers
•Support for FC arbitrated loop, private and public attachment
•Differential copper FC drivers and receivers
•Downloadable firmware using the
•Supports SCSI enclosure services via interface connector
•
•Supports up to 32 initiators
•Drive selection ID and configuration options are set on the
•Fibre Channel worldwide name uniquely identifies the drive and each port
•
•Selectable frame sizes from 256 to 2,112 bytes
•Industry standard
•Programmable logical block reallocation scheme
•Flawed logical block reallocation at format time
•Programmable auto write and read reallocation
•
•Sealed head and disc assembly (HDA)
•No preventive maintenance or adjustments required
•Dedicated head landing zone
•Automatic shipping lock
•Embedded Grey Code track address and servo wedge address to eliminate seek errors
•
•1:1 interleave
•Zone bit recording (ZBR)
•Vertical, horizontal, or top down mounting
•Dynamic spindle brake
•8,192 Kbyte data buffer. See Section 4.5.
•Embedded servo design
•Reallocation of defects on command (Post Format)
•Fibre Channel interface transports SCSI protocol
3.2Media description
The media used on the drive has a diameter of approximately 84 mm (approximately 3.3 inches). The alumi- num substrate is coated with a thin film magnetic material, overcoated with a proprietary protective layer for improved durability and environmental protection.
3.3Performance
•Programmable
•200 Mbytes/sec maximum instantaneous data transfers per port
•10K RPM spindle; average latency = 2.99 msec
•Command queuing of up to 128 commands
•Background processing of queue
•Supports start and stop commands
•Adaptive seek velocity; improved seek performance
3.4Reliability
•1,200,000 hour MTBF
•LSI circuitry
•Balanced low mass rotary voice coil actuator