34 | Cheetah 10K.6 FC Product Manual, Rev. B |
Drive
Front
Pin 1
J6
Reserved
Port A Bypass LED [1]
Port B Bypass LED [1]
Fault LED [1]
Reserved
Active LED [2]
Reserved
+5V
Active LED [1]
Ground [3]
[1]The drive has a 1.2K ohm resistor in series with this LED driver. Tie the minus side of an external
[2]An external
[3]Jumper storage location (across pins 2 and 4).
Figure 17. LED indicator connector
8.2.1J6 connector requirements
Recommended mating connector part number: Berg receptacle,
8.3Drive orientation
The drive may be mounted in any orientation. All drive performance characterizations, however, have been done with the drive in horizontal (discs level) and vertical (drive on its side) orientations, which are the two pre- ferred mounting orientations.
8.4Cooling
Cabinet cooling must be designed by the customer so that the ambient temperature immediately surrounding the drive will not exceed temperature conditions specified in Section 6.3.1, "Temperature."
The rack, cabinet, or drawer environment for the drive must provide heat removal from the electronics and head and disc assembly (HDA). You should confirm that adequate heat removal is provided using the tempera- ture measurement guidelines described in Section 6.3.1.
Forced air flow may be required to keep temperatures at or below the temperatures specified in Section 6.3.1, in which case the drive should be oriented, or air flow directed, so that the least amount of air flow resistance is