38 | Elite 23 Installation Guide, Rev. A |
W/WD drives
Setting the SCSI ID jumpers
Use the J4A jumper block to set the SCSI ID (Figure 11) on mod- els ST423451W/WD. To change the SCSI ID, install jumpers on the appropriate pins as shown in the illustration.
Pin 15 | Pin 1 | J4A |
J4A |
| |
|
| |
Pin 1 |
|
|
SCSI ID = 0 (default)
SCSI ID = 1
SCSI ID = 2
SCSI ID = 3
SCSI ID = 4
SCSI ID = 5
SCSI ID = 6
SCSI ID = 7
SCSI ID = 8*
SCSI ID = 9*
SCSI ID = Ah (10)*
SCSI ID = Bh (11)*
SCSI ID = Ch (12)*
SCSI ID = Dh (13)*
SCSI ID = Eh (14)*
SCSI ID = Fh (15)*
J6 | J4B |
SCSI I/O |
|
Connector |
|
DC Power | Pin 1 |
Connector |
|
