Seagate ST43400N/ND user manual Mounting the drive

24

Mounting the drive

The drive may be secured to the enclosure via tapped holes in either the sides or the bottom of the drive chassis. Figure 10 shows two of the three allowable orientations.

Note. The mounting screws must be completely engaged in the drive chassis, but the portion that extends into the chassis must not exceed

3.2mm (0.125 in) in length.

1.Place the drive into position in the enclosure and secure with four screws as shown in Figure 10.

•For bottom mounting, use 6-32 screws.

•For side mounting, use either 6-32 screws or M4 X .70 (metric) screws. There are tapped holes for each type.

2.Connect the 9-pin connector of the DC power cable to the output connector on the power supply. Connect the 4-pin connector of the same cable to the DC power connector J15 on the drive.

3.Connect the AC power cord to site power.