33

Section 3. Operation

This section provides the information and instructions to operate the drive. It includes the following topics:

Switches and indicators—locates and describes the switches and indicators used for normal drive operation.

Operating instructions—describes procedures for operating the drive.

Switches and indicators

Following initial checkout, the drive normally requires no attention from the operator. Although power is usually left on, as the operator you should know where the on/standby switch is located on the power supply. Also, you may be asked to examine the maintenance LEDs.

Two of the maintenance LEDs are located on the drive’s control board. The third maintenance LED is located either on the control board or on an optional bezel (if the bezel is installed). Figure 16 shows these switches and indica- tors. They are explained in Table 7 following the figure.

Page 38
Image 38
Seagate ST43400N/ND user manual Operation, Switches and indicators