Seagate ST9320328CS, ST9500323CS 3 S.M.A.R.T. commands, Code in features register A.R.T. command

Models: ST9500323CS ST9320328CS

1 46
Download 46 pages 42.61 Kb
Page 39
Image 39

Table 8: Set Features command values

82H

Disable write cache

86H

Disable PUIS feature set

AAH

Enable read look-ahead (read cache) feature (default).

F1H

Report full capacity available

Note. At power-on, or after a hardware or software reset, the default values of the features are as indicated above.

4.3.3S.M.A.R.T. commands

S.M.A.R.T. provides near-term failure prediction for disc drives. When S.M.A.R.T. is enabled, the drive monitors predetermined drive attributes that are susceptible to degradation over time. If self-monitoring determines that a failure is likely, S.M.A.R.T. makes a status report available to the host. Not all failures are predictable. S.M.A.R.T. predictability is limited to the attributes the drive can monitor. For more information on S.M.A.R.T. commands and implementation, see the Draft ATA-8 Standard.

SeaTools diagnostic software activates a built-in drive self-test (DST S.M.A.R.T. command for D4H) that eliminates unnecessary drive returns. The diagnostic software ships with all new drives and is also available at: http://seatools.seagate.com.

This drive is shipped with S.M.A.R.T. features disabled. You must have a recent BIOS or software package that supports S.M.A.R.T. to enable this feature. The table below shows the S.M.A.R.T. command codes that the drive uses.

Table 9:

S.M.A.R.T. commands

 

 

Code in features register

S.M.A.R.T. command

 

 

 

D0H

 

S.M.A.R.T. Read Data

D1H

 

Vendor-specific

D2H

 

S.M.A.R.T. Enable/Disable Attribute Autosave

D3H

 

S.M.A.R.T. Save Attribute Values

D4H

 

S.M.A.R.T. Execute Off-line Immediate (runs DST)

D5H

 

S.M.A.R.T. Read Log Sector

D6H

 

S.M.A.R.T. Write Log Sector

D7H

 

Vendor-specific

D8H

 

S.M.A.R.T. Enable Operations

D9H

 

S.M.A.R.T. Disable Operations

DAH

 

S.M.A.R.T. Return Status

Note. If an appropriate code is not written to the Features Register, the command is aborted and 0x04 (abort) is written to the Error register.

Pipeline HD Mini Series SATA Product Manual, Rev. E

29

Page 39
Image 39
Seagate ST9320328CS, ST9500323CS manual 3 S.M.A.R.T. commands, Code in features register A.R.T. command