www.seagate.com | Drive Specifications |
2.7Start/stop times
|
| |||||||
| (3TB, 2TB | (2TB, 1.5TB | (1TB, 750GB | (250GB, 320GB, | ||||
| models) | models) | models) | 500GB models) | ||||
|
|
|
|
|
|
|
| |
15 | (typical) | 15 | (typical) | 10 | (typical) | 8.5 (typical) | ||
( in seconds) | 17 | (max) | 17 | (max) | 12 | (max) | 10 | (max) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
<10 | <10 | n/a | n/a | |||||
(in seconds, typical) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Standby to ready | 15 | (typical) | 15 | (typical) | 10 | (typical) | 8.5 (typical) | |
(in seconds) | 17 | (max) | 17 | (max) | 12 | (max) | 10 | (max) |
|
|
|
|
|
|
|
|
|
Ready to spindle stop | 10 | (typical) | 10 | (typical) | 10 | (typical) | 10 | (typical) |
(in seconds) | 11 | (max) | 11 | (max) | 11 | (max) | 11 | (max) |
|
|
|
|
|
|
|
|
|
2.8Power specifications
The drive receives DC power (+5V or +12V) through a native SATA power connector. Refer to Figure 1 on page 26.
2.8.1 Power consumption
Power requirements for the drives are listed in Table 3, Table 4, Table 5 and Table 6. Typical power measurements are based on an average of drives tested, under nominal conditions, using 5.0V and 12.0V input voltage at 25°C ambient temperature.
•Spinup power
Spinup power is measured from the time of
•Read/write power and current
Read/write power is measured with the heads on track, based on a
• Operating power and current
Operating power is measured using 40 percent random seeks, 40 percent read/write mode (1 write for each 10 reads) and 20 percent drive idle mode.
• Idle mode power
Idle mode power is measured with the drive up to speed, with servo electronics active and with the heads in a random track location.
• Standby mode
During Standby mode, the drive accepts commands, but the drive is not spinning, and the servo and read/ write electronics are in
Barracuda SATA Product Manual, Rev. G | 17 |
