Seagate ST750DM003, STBD3000100 Identify Device command, Word Description Value, 0C5AH, Ascii

www.seagate.com SATA Interface

4.3.1 Identify Device command

The Identify Device command (command code ECH) transfers information about the drive to the host following power up. The data is organized as a single 512-byte block of data, whose contents are shown in on page 30. All reserved bits or words should be set to zero. Parameters listed with an “x” are drive-specific or vary with the state of the drive.

The following commands contain drive-specific features that may not be included in the SATA specification.

Table 11 Identify Device commands

Word	Description	Value
0	Configuration information:	0C5AH
	• Bit 15: 0 = ATA; 1 = ATAPI
	• Bit 7: removable media
	• Bit 6: removable controller
	• Bit 0: reserved
1	Number of logical cylinders	16,383
2	ATA-reserved	0000H
3	Number of logical heads	16
4	Retired	0000H
5	Retired	0000H
6	Number of logical sectors per logical track: 63	003FH
7–9	Retired	0000H
10–19	Serial number: (20 ASCII characters, 0000H = none)	ASCII
20	Retired	0000H
21	Retired	0400H
22	Obsolete	0000H
23–26	Firmware revision	x.xx
	(8 ASCII character string, padded with blanks to end of
	string)
27–46	Drive model number:
	(40 ASCII characters, padded with blanks to end of string)
47	(Bits 7–0) Maximum sectors per interrupt on Read multiple	8010H
	and Write multiple (16)
48	Reserved	0000H
49	Standard Standby timer, IORDY supported and may be	2F00H
	disabled
50	ATA-reserved	0000H
51	PIO data-transfer cycle timing mode	0200H
52	Retired	0200H
53	Words 54–58, 64–70 and 88 are valid	0007H
54	Number of current logical cylinders	xxxxH
55	Number of current logical heads	xxxxH
56	Number of current logical sectors per logical track	xxxxH
57–58	Current capacity in sectors	xxxxH

Barracuda SATA Product Manual, Rev. G 33