Seagate ST250DM000, STBD3000100 Supported ATA commands, Command name Command code in hex, E5H

SATA Interface www.seagate.com

Table 9 SATA connector pin definitions (continued)

Segment	Pin	Function	Definition
	P1	V33	3.3V power
	P2	V33	3.3V power
	P3	V33	3.3V power, pre-charge, 2nd mate
	P4	Ground	1st mate
	P5	Ground	2nd mate
	P6	Ground	2nd mate
	P7	V5	5V power, pre-charge, 2nd mate
Power	P8	V5	5V power
	P9	V5	5V power
	P10	Ground	2nd mate
	P11	Ground or LED signal	If grounded, drive does not use deferred spin
	P12	Ground	1st mate.
	P13	V12	12V power, pre-charge, 2nd mate
	P14	V12	12V power
	P15	V12	12V power

Notes

1.All pins are in a single row, with a 1.27 mm (0.050 in) pitch.

2.The comments on the mating sequence apply to the case of backplane blindmate connector only. In this case, the mating sequences are:

•the ground pins P4 and P12.

•the pre-charge power pins and the other ground pins.

•the signal pins and the rest of the power pins.

3.There are three power pins for each voltage. One pin from each voltage is used for pre-charge when installed in a blind-mate backplane configuration.

•All used voltage pins (Vx) must be terminated.

4.3Supported ATA commands

The following table lists SATA standard commands that the drive supports.

For a detailed description of the ATA commands, refer to the Serial ATA International Organization: Serial ATA Revision 3.0 (http://www.sata-io.org).

See “S.M.A.R.T. commands” on page 38 for details and subcommands used in the S.M.A.R.T. implementation.

Table 10 SATA standard commands

Command name	Command code (in hex)
Check Power Mode	E5H
Device Configuration Freeze Lock	B1H / C1H
Device Configuration Identify	B1H / C2H
Device Configuration Restore	B1H / C0H
Device Configuration Set	B1H / C3H
Device Reset	08H

30 Barracuda SATA Product Manual, Rev. G