1_ Loo_n Tne Qamplng _or_w'_ _wn_ mJ _tl _m _€;,nne'ls
•(item 2).
2.Adiust nuts (Item 3) by alternating loosening and tighten- ing so that the channels are moved up or down an the a_justing screws (Item 4) in the desired direction.
3.When channels are properly adjusted the arbor wrench
wifl just contact the table top when swung back and forth at Positions 1, 2, 3, and 4 of Figure 9_ Tighten clamping screws (Item 1). Recheck the four positions to insure that no change has occurred.
ATTACHING THE SAW BLADE
1.Remove shaft nut and one loose colarm
2.Place saw blade on motor shaft taking care that saw blade teeth are in some direction as shown in Figure 11_
3.Replace other loose coltar and shaft nut° Smooth face of €olor must be away from saw blade.
,4. Use arbor wrench (item 1, figure 12 on motor shaft nut and shaft wrench (Item 2, figure 12) on slot in motor shaft to tighten shaft nut.
CAUTION:
SHAFT NUT
HAS LEFT
HAND
THREADS
:_IUAICII_ UM" :_AW ISI.AU= _ In" IAnLC lur
1.Place edge of combination square or accurate steel square on table top and position as shown in Figure 13. Square must be held firmly against table tap°
2.When blade is _uare to the table no light will be v_ible between square and face of saw blade. Do not allow
square to rest on saw teeth.
If light is visible between steel square and face of sow blade adjust as follows:
a.Loosen bevel lock knob (Item I, figure 13). Use 7/32 hex "L" wrench and sllghfly loosen four socket head screws (item 2, figure 13).
b.Hold motor shaft at one end and tilt motor in proper direction until saw blade is square to table top. See
Step 2 above_
c. Retlghten socket head screws (Item 2, figure 13) and bevel lock knob (Item 1, figure 13).
d. Recheck blade _uareness to table top since tighten- ing of screws may have shifted motor.
e.Indicator (item 3, figure 13) should read 0 ° on bevel index scole_If not, loosen screw and adjust indicator.
Retlghten screw.
CHECKING COLUMN TUBE KEY
if excessive radla arm movement is noticed even though the arm is locked in position, check the fit of the column tube key (Item 2, figure 14) and the keyway in the column tube.
To Loosen Shaft Nut
" ° "_ | Figure 11 |
CAUTION:
SHAFT NUT
HAS LEFT
HAND THREADS
| ro Tighten |
Figure 12 | Shaft Nut |
2
Figure 13
Figure 14
1.Adjust by loosening the socket set screw (Item I, figure 14), using the 7/16 hex "'L'"wrench°
2.Pressvigorously against the rear of the column tube key (Item 2, figure 14) or
key to seat properly in the keyway°
3o Tighten the set screw (item 1, figure 1`4) securely whffe maintaining pressure on the key°
SQUARING THE CROSS CUT TRAVEL TO THE FENCE 1_ Set radial arm at 0 ° index position and tighten arm latch handle_ See Page 11 "Angular Movement and Locking of the Radial Arm" for the most positive and
accurate sewings at an index Posilion,
Figure 15
9
