Basic Saw | Operations | (Continued) | |
Tips for Cutting | Compound | Miters | Tips For Cutting Crown Molding Lying Flat |
Model 113.235220 & 113,235240 | Only: | Model 113,235220 & 113.235240 Only: | |
A compound miter is a cut requiring both a miter setting and bevel setting A compound miter is used for making frames or boxes that have sloping sides and are wide at one end and narrow at the opposite end, Compound miters are "tricky" to make because the miter setting and bevel setting are directly related to each other Every time the miter setting is changed the bevel set- ting must also be adjusted; likewise every adjustment to bevel requires a corresponding adjustment to miter, Because it may take several tries to obtain the desired angle it as advisable to make test cuts in a scrap piece of material.
Cutting Crown Moldings
Plan Ahead so that you are not tempted to reach across saw blade to steady newly severed workpiece
Two Methods to Cut Crown Moldings
1, Workpiece standing up, usua!ly cut inverted from ceiling mounted orientation. Fixturing: Accessory mounted crown molding jigs which locate workpiece See recommended accessories (Table clamp is helpful) Hand is on fence when the cuts are made. All cuts are made at 0 ° bevel setting (see illustra- tion).
Alternate fixturing: Auxiliary fence as shown on page 19 plus table clamps.
2. Workpiece lying flat for compound cut (see chart),
Model 113,235220 & 113.235240 Only:
Miter and Bevel Settings for Standard
Crown Molding Lying Flat on Miter Saw
Table.
BEVEL | MITER |
| TYPE OF CUT | ||
SETTING | SETTING |
|
|
|
|
|
| LEFT SIDE, INSIDE CORNER | |||
338 ° | 31 6° | I | Position | top molding | against |
|
|
| fence |
|
|
| Right | 2 | Left side is finished | piece | |
|
| RIGHTSIDE, INSIDECORNER | |||
33 8 ° | 31 6 ° | 1 | Positionbottom of molding | ||
| Left |
| againstfence |
| |
| 2 | Leftside is finished piece | |||
33 8° | 3! 6° | LEFT SIDE, OUTSIDECORNER | |||
1 | Positionbottom of molding | ||||
| Left |
| againstfence |
| |
| 2 | Right side is finished piece | |||
|
| RIGHT SIDE, OUTSIDE CORNER | |||
338 ° | 31 6 o | 1 | Position | top of molding | |
|
|
| against | fence, |
|
| Right | 2 | Right side is finished piece | ||
NOTE: On all above cuts lay molding with broad back surface flat on table
PRETESTING COMPOUND SETTINGS ON SCRAP MATERIAL IS EXTREMELY IMPORTANT!
A compound miter saw is excellent for cutting crown molding. Crown molding is difficult to cut because in order to fit correctly it must be precisely mitered,
All Standard (US) crown molding has a top rear angle (fits next to ceiling) of 52 ° and a bottom rear angle (fits against wall) of 38°
NOTE: Above angles assume that the constructed wall corner is exactly 90" In typical construction, this is not always the case. Measure wall and make necessary adjustments to angles
Inside._
Corner f | X_ |
21
