Sears 139.53915D Using the Wall.Mounted Door Control, To Open the Door Manually, Feature

Using the Wall.Mounted Door Control

THE MOTION DETECTING CONTROL

CONSOLE

Press the push bar to open or close the
door. Press again to reverse the door			Push
during the closing cycle or to stop the			Bar
door	while it'sopening.
			Lock
This door control contains a motion
			Bu_on
detector that will automatically		turn on
			Light
the light when it detects a person			Button
entering the garage. This feature can be
easily	turned off for extended	work light	use.
Light	feature

To Open the Door Manually

To prevent possible SERIOUSINJURYor DEATHfrom a falling garage door:

•If possible, use emergency releasehandle to disengage trolley ONLYwhen garage door is CLOSED.Weakor broken springs or unbalanced door could result in an open door falling rapidly and/or unexpectedly.

•NEVERuse emergency releasehandle unless garage doorway is clear of persons and obstructions.

•NEVERuse handleto pull door open or closed. If rope knot becomes untied,you could fall.

Press the Light button to turn the opener light on or off. It will not control the opener lights when the door is in motion. If you turn it on and then activate the opener, the light will remain on for 4-1/2 minutes. Press again to turn it off sooner. The 4-1/2 minute interval can be changed to 1- 1/2, 2-1/2, or 3-1/2 minutes as follows: Press and hold the Lock button until the light blinks (about 10 seconds). A single blink indicates that the timer is reset to 1-1/2 minutes. Repeat the procedure and the light will blink twice, resetting the timer to 2-1/2 minutes. Repeat again for a 3-1/2 minute interval, etc., up to a maximum of four blinks and 4-1/2 minutes.

DISCONNECT THE TROLLEY:

The door should be fully closed if possible. Pull down on the emergency release handle (so that the trolley release arm snaps into a vertical position) and lift the door manually. The lockout feature prevents the trolley from reconnecting automatically, and the door can be raised and lowered manually as often as necessary.

Trolley -- ...J

Release Arm

(in Manual

Disconnect

Position)

Lock feature

Designed to prevent operation of the door from hand-held remote controls. However, the door will open and close from the Door Control, the Outdoor Key Switch and the Keyless Entry Accessories.

To activate, press and hold the Lock button for 2 seconds. The push button light will flash as long as the Lock feature is on.

To turn off, press and hold the Lock button again for

2 seconds. The push button light will stop flashing. The Lock feature will also turn off whenever the "learn" button

on the motor unit panel is activated.

TO RE-CONNECT THE

TROLLEY:

Pull the emergency release handle toward the opener at an angle so that the trolley release arm is horizontal. The trolley will reconnect on the next UP or DOWN operation, either

manually or by using the door control or remote.

Lockout position

(Manual disconnect)

Trolley

I

i i i_1,, ,

Trolley

Release

_, X Arm

Emergency "'_

Release Handle _ "%,.._

Additional feature when used with the 3-Function hand-held remote

To control the opener lights:

In addition to operating the door, you may program the remote to operate the lights.

1.With the door closed, press and hold a small remote button that you want to control the light.

2.Press and hold the Light button on the door control.

3.While holding the Light button, press and hold the Lock button on the door control.

4.After the opener lights flash, release all buttons.

(Down and Back) "'"_,_,.[_'

To reconnect

31