Sears 149.213340 warranty General Safety Rules, For Power Tools

FULL ONE-YEAR WARRANTY ON CRAFTSMAN RADIAL DRILL PRESS

If within one year from date of purchase, this Craftsman RADIAL DRILL PRESS fails due to a defect in materi- al or workmanship, Sears will repair it, free of charge

WARRANTY SERVICE IS AVAILABLE BY CONTACTING THE NEAREST SEARS STORE OR SERVICE CENTER IN THE UNITED STATES,

. This warranty gives you specific legal rights and you may also have other rights that vary from state to state

Sears, Roebuck and Co., 13/817WA, Hoffman Estates, IL 60179.

GENERAL SAFETY RULES

KNOW YOUR POWER TOOL

For your own safety, read the owner's manual carefully Learn the application and limitations as well as the specific hazards peculiar to this tool

2 GROUNDING INSTRUCTIONS

A. All grounded, cord-connected tools:

In the event of a malfunction or breakdown, grounding pro- vides a path of least resistance for electric current to reduce the risk of electric shock This tool is equipped with an electric cord having an equipment-grounding conductor and a grounding plug The plug must be plugged into a

matching outlet that is properly installed and grounded in accordance with all local codes and ordinances

FOR POWER TOOLS

Extension Cords suitable for use with your Radial Drill

Press are available at your nearest Sears Catalog Order or Retail Store

Repair or replace damaged or worn cord immediately

S Grounded, cord-connected tools intended for use on a supply circuit having a nominal rating less than 150 volts:

Metal S_

rofGroundedII ['1)II

utlet Box

Do not modify the plug provided - if it will not fit the outlet, have the proper outlet installed by a qualified electrician

Improper connection of the equipment-grounding conduc* tot can result in a risk of electric shock The conductor with insulation having an outer surface that is green with or without yellow stripes is the equipment-grounding conduc- tor If repair or replacement of the electric cord or plug is

necessary, do not connect the equipment-grounding con- ductor to a live terminal

Check with a qualified electrician of serviceman if the grounding instructions are not completely understood, or if in doubt as to whether the tool is properly grounded

The use of any Extension Cord will cause some loss of power To keep this to a minimum and to prevent over- heating and motor buro-out, use the table below to deter÷ mine the MINIMUM wire size (A W.G ) Extension Cord

Use only 3-wire extension cords :_hathave 3-prong ground- ing plugs, and 3-pole receptacles that accept the tool's plug

Extension Cord Length		Wire Size, AW G
25	Feet	16
50	Feet	16
100 Feet		14

{A)(a)

Grounding Pin

Adapter

Groundin(

Figure I - Wiring Methods

This tool is intended for use on a circuit that has an outlet that looks like the one illustrated in Sketch A in Figure 1, The tool has a grounding plug that looks like the plug illus- trated in Sketch A in Figure 1 A temporary adapter, which looks like the adapter illustrated in Sketches B and C, may be used to connect this plug to a 2-pole receptacle as shown in Sketch B if a properly grounded outlet is not available The temporary adapter should be used only until a properly grounded outlet can be installed by a qualified electrician The green-colored rigid ea_:, lug, etc extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box

3 KEEP GUARDS IN PLACE

in working order and in proper adjustment and alignment,

2