Sears 149.213340 warranty NNSTALUNG Radual Drull Press

f

I

7Make sure bottom of Spindle Shaft (REF 42) and bore of Chuck (REF 46) are clean and free of grease Press Chuck up onto Spindle Shaft_

NOTE: To avoid damage to Chuck, rotate Chuck barrel until jaws are fully open.

8Using a mallet or a block of wood and hammer, firmly tap Chuck upward into position onto Spindle Shaft

nNSTALUNG RADUAL DRULL PRESS

WARNING: BEFORE USING RADIAL DRILL PRESS_

MAKE SURE IT IS ATTACHED TO A FIRM AND STABLE SUP-

PORT SURFACE USING CARRIAGE BOLTS AND WING NUTS PROVIDED.

12 3/4" Fore and Aft Travel

1Choose an area that allows sufficient clearance to take full advantage of the Radial Drill Press's lateral, rota- tional, and tilt motions

2Bolt Radial Drill Press to a firm and stable surface using Carriage Bolts and Wing Nuts provided, Be sure bolts pass entirely through mounting surface and are at least 5/16-18 standard strength_ Tighten all bolts and wing nuts securely

3/8" Diameter

2 Hotes

6 1/4"

Head Tilts 45"

C_ockwise and 90"360" Rotation

Counter-clockwise

Use Carriage Bolts and Wing Nuts Provided

7