ASSEMBLY
WARNING: FOR YOUR OWN SAFETY, NEVER CONNECT THE RADIAL DRILL PRESS TO A POWER SOURCE UNTIL ALL ASSEMBLY STEPS ARE COMPLETE_ AND YOU HAVE
READ AND UNDERSTOOD SAFETY AND OPERATIONAL INSTRUCTIONS=
CAUTION: Do NOT ALLOW BRAKE FLUIDS_ GASOLINE,
PENETRATING OILS 1 ETC,_ TO COME IN CONTACT WITH
PLASTIC PARTS, THESE SOLUTIONS CONTAIN CHEMICALS THAT CAN DAMAGE AND/OR DESTROY PLASTICS,
1Assemble Column and Flange Assembly (REF 4) to Base Assembly (REF 1) using four 8mm x 25mm bolts (REF 5).
2Slide Worm Pinion (REF 9) into Table Bracket (REF 6) until shaft extends from hole and teeth engage with Table Lift Gear (REF 7) Lower Vertical Rack (REF 15) into Table
Lift
Handle
Bracket making sure that the teeth are engaged in the Table Lift Gear inside bracket Slide rack and bracket assembly onto column until angled end at bottom of rack fits into top of column flange
Place Lift Handle (REF 10) on Worm Pinion Shaft extending from Table Bracket Align flat on pinion shaft with set screw (REF 11) and tighten
NOTE: Before installing drill head assembly, find a per- manent location for radial drill press and fasten base down using Carriage Bolts (REF 96) and Wing Nuts (REF
97) provided. BE SURE BOLTS PASS ENTIRELY THROUGH MOUNTING SURFACE. (See Installing Radial Drill Press section on page 7,)
4Race Lock Shoe (REF 88) from loose parts bag into cast pocket in Column Head Assembly (REF 83) then slide Column Head Assembly with Drilt Head Assembly down onto Column as shown Be very careful to hold Lock Shoe in place during assembly to prevent it from falling down inside column Be sure to engage Vertical Rack with angle on bottom of Column Head Drill head should rotate freely around column
Lock
Lock
Handle
Handle
Bar
Lift
5Attach one Lock Handle (REF 14) to Table Bracket and two Lock Handles to Column Head_
6, Attach three Handle Bars (REF 37) into threaded holes on head of Feed Shaft Assembly (REF 34)
Table Bracket
